[DISCONTINUED] SLE3/4G-CFB-PS Napco StarLink Commercial Fire/ Burglary, GSM, Red Enclosure with 120V Hardwired Power Supply - AT&T

The StarLink models SLECDMA-CFB-PS and SLE3/4G-CFB-PS are fully supervised, sole path approved, commercial cellular fire alarm communicators supported by an extensive na􀆟onwide wireless network. Both are designed for direct connec- 􀆟on to a dedicated 120V AC circuit, or may be powered by an op􀆟onal plug-in style transformer (see WI for required installa􀆟on methods). Both models are approved for use as a sole path primary Fire Alarm communicator or as a backup to exis􀆟ng telephone lines. In backup mode, the units will automa􀆟cally switch the communica􀆟on channel from the telephone line to the network when a telephone line trouble is detected. See WI2140 for programming informa􀆟on. The SLE Series radios use data-capture technology that captures the alarm report from the control panel and transmits the alarm signals to the SLE Network Operations Center; the alarm signals are then forwarded to ANY central station via Contact ID or 4/2 central sta􀆟on formats. The radios can also report to a Sur-Gard System II central sta􀆟on receiver via TCP/IP using standard line security. The SLE Network Operations Center reports a trouble signal in the event that the network does not receive the expected supervision signal from the wireless communicator.

Specifications

Electrical Ratings for 120VAC, 60Hz For Models with Power Supply

• Input Voltage: 120VAC nominal
• Input Current: 400mA maximum
• Maximum Charging Current: 200mA

Electrical Ratings for the IN 1 Burg/Fire Input:

• Input Voltage: 9-15VDC.
• Maximum Input Current: Up to 2mA from FACP NAC circuit

Electrical Ratings for IN 2 and IN 3:

• Maximum Loop Voltage: 15VDC.
• Maximum Loop Current: 1.2mA
• End of Line Resistor (EOLR) Value: 10K (2 req'd)

Electrical Ratings for 3 PGM Outputs:

• Open Collector Outputs: Maximum Voltage 3V when active; 15V maximum when not active.
• Maximum PGM Sink Current: 50mA (up to 15VDC), 25mA (15.1VDC - 25VDC)

Physical (W x H x D)

• Metal Housing: 111/2 x 91/2 x 31/2" (29.2 x 24.1 x 8.9cm)
• Mounting: Metal housing includes two keyhole slots for wall mounting

Environmental

• Operating Temperature: 0^ºC - 49^ºC (32^ºF - 120^ºF)
• Humidity: Maximum 93% Non-Condensing
• Indoor / dry location use only

SLE3/4G-CFB-PS Specifications PDF