[DISCONTINUED] VHW-HWQ Veracity Highwire Quad with 4 Power over Ethernet Out Ports

HIGHWIRE QUAD integrates Veracity's HIGHWIRE Ethernet over coaxial cable technology with a four-port PoE switch. This means that up to four IP cameras can be installed in place of an old analog video camera. Legacy coax cabling can be used as a network connection, and an existing 12VDC or 24VAC supply can be converted into universal Power over Ethernet (PoE) for the new IP cameras.

Specifications:

HIGHWIRE INTERFACE:

• Connector type: BNC 75ohm
• Cable impedance: 75ohm (RG59 or similar)
• Cable length max: Up to 800ft for full data rate (or up to 1100ft at a reduced rate)
• Data throughput max: 200Mbps (total up + down). Auto-adaptation to cable conditions.

ETHERNET INTERFACE:

• Connector type: RJ45
• Cable type: Straight through or cross-over, auto detected
• Rates supported: 100BaseT / 10BaseT, full/half duplex with auto negotiation

LED INDICATORS:

• Green – Constant: Power OK, Full HIGHWIRE data link
• Green – Slow: Power OK, Auto-adapted HIGHWIRE data link
• Green – Blink: Power OK, no HIGHWIRE link
• Green – Off: No power
• Amber – Constant: Ethernet link On
• Amber – Blink: Network traffic

POWER SUPPLY:

• Connector type: Screw terminals with detachable plug
• Power supply type: IEC Class II isolated only
• Operating voltage: Nominal 12V DC (9-24V working range) or 24V AC (type and polarity auto detected)
• Supply current: 200mA (12V), 100mA (24V)

ENVIRONMENTAL:

• Operating temp.: 14ºF to 122ºF
• Relative humidity: 85% non-condensing
• Grounding: Chassis should be grounded and is connected to the BNC shield.
• Dimensions: L 4.01” (3.27” excl. conns.) x W 2.13” x H 0.91”
• Weight: 4 oz. (110g)
• Compliance: FCC, CE, RoHS

VHW-HWQ Specifications PDF