HPSA-7104-R Cooper Wheelock High Powered Speaker Array Wired 4 Horns Regulatory

WAVES High Power Speaker Arrays (HPSA-7100-R Series) broadcast intelligible voice messages and tones, covering large geographic areas. Designed to meet Life Safety requirements, CE mark approval and TUV certification, this Wide-area Mass Notification System (MNS) features industry-leading intelligibility using an advanced amplification system design. Deployed on a static pole, affixed to a building or mounted on a rooftop, the HPSAs have a variety of installation options. These Giant Voice speaker arrays ensure that you get the right message to the right person at the right time.
The HPSA-7100-R Series can be integrated and controlled by either voice-capable Fire Alarm Control Panels (FACP) or Cooper Notification’s SAFEPATH (SP40S) Voice Evacuation Systems or SAFEPATH Mass Notification Systems (SPMNS). The supervised NAC input of the HPSA is designed to activate and de-activate audio at the HPSA by applying 24 VDC in the appropriate polarity or contact closure. The NAC input does not accept audio directly. There is a separate input to bring audio into the HPSA that supports 70 V, 25 V or 1 V audio.

Specifications

External Interface

• NAC Input - PTT Activation. 9 - 40 VDC, 17 mA Max.
• Dry Contact Input - PTT Activation (alternative to NAC Input). 250ms < 1 K Ohms.
• Audio Input - 70.7 vRMS, 25 vRMS or 1 vRMS selectable (set SW1 on Audio and Monitoring Bridge interface board to 70/25 vRMS or 1 vRMS respectively). 1mW load for 70.7 vRMS or 25 vRMS settings.
• Trouble Outputs - Form C, dry contact. 2 Amps., 30VDC (resistive). Max. Trouble Signals (6) provided: AC, No Battery, Low Battery, Tamper, Amplifier Fault and Driver Fault.

General Specifications

• Electronic Cabinet Dimensions - 36” W x 48” H (60” with pedestals) x 12” D / 91.4 x 121.9 (152.4 with pedestals) x 30.5 cm
• Electronic Cabinet Weight - 110 lbs (not including batteries) / 49.9 kg; Total weight with batteries: 322 lbs / 146 kg
• Horn Dimensions - 3’ 2” W x 2’ 1” H x 1’ 4 7/16” D / 96.52 cm x 63.5 cm x 41.91 cm (2 horns with drivers, omni-directional)
• Horn Weight - 52 lbs for each horn and driver kit (pair) / 23.6 kg
• Horn Material - Special aluminum alloy horn construction provides long service life without material fatigue
• Battery Weight - 53 lbs each / 24 kg
• Speaker Mounting/Pipe Pole - Minimum 4.5” (11 cm) outside diameter (OD); Maximum 6” OD (15.25 cm)
• Ground Mount Pedestal Kit - Model M37-00056 raises the cabinet 12” (30.5) cm) from the ground
• Speaker Cable Kit - Model CAB-SKR-KIT, 500 ft (152 m) long; 16 AWG stranded, non-shielded, marine-rated
• Speaker Wire - 14 - 16 AWG stranded two-conductor jacketed cable. Non-shielded either twisted or non-twisted. UL/CSA/EU-approved for outdoor use
• Wire Size Ratings
  • Speaker Lines: 12 - 16 AWG (limited to 14 AWG for connectors)
  • AMB Lines: 12 - 22 AWG
  • AC Mains: 10 - 16 AWG

Power (Including Standby)

• Input Voltage - 120 to 240 VAC; 50 to 60 Hz Single-phase (Universal AC/Auto-switching)
• Input Current - 3 Amps
• Battery Input Voltage - 40.8 - 55.4 VDC 48 Volts (nominal)
• Operating Voltage - ~48 VDC
• Standby Time - 72 hrs followed by 60 min continuous voice
• Continuous Signaling Time - 60 minutes (voice)
• Battery Charger - Universal AC Supply, 4 Amp maximum
• Batteries - Four (4) deep cycle discharge AGM, SLA batteries. 65 AH each, connected in series

Amplifiers

• Amplifier - Class D
• Frequency Response - 300 Hz to 7 kHz (Driver, typical); 20 Hz to 20 kHz (Amp, typical)
• Total Harmonic Distortion - .1% THD+N Capable; 10% THD+N Max to achieve specified SPL levels
• Efficiency - Greater than 90% at full load
• Thermal Protection - Yes
• Short Circuit Protection - Yes, Auto Recovery
• Driver Impedance - 11 Ohm (Typical)

Environment

• Operating Temperature - -40^º F to 140^º F (-40^º C to +60^º C)
• Electronic Cabinet Rating - NEMA 4X, IP66, UL508 cabinet
• Transient Protection - Built-in lightning protection on mains, external interfaces, and speaker lines

HPSA-7104-R Specifications PDF