POE75U-1UP-PD Phihong Ultra Power over Ethernet Single Port Injector

Specifications

Input

• AC Input Voltage Range - 90 to 264VAC
• AC Input Voltage Rating - 100 to 240VAC
• AC Input Current
  • 2.0A (RMS) maximum for 90VAC
  • 1.2A (RMS) maximum for 240VAC
• AC Input Frequency - 47 to 63Hz
• Leakage Current - 3.5mA for 254VAC, 50Hz
• Max Inrush Current
  • 30A for 115VAC at maximum load
  • 60A for 230VAC at maximum load

Output

• Total Output Power - 75W
• Ripple and Regulation - 250mV maximum
• DC Offset - No data degradation with DC imbalance 18mA per min.
• Efficiency - 80% (typical) at maximum load, and 120VAC 60Hz
• Hold-up Time - 10mS min. 120VAC and maximum load
• Transient O/P Voltage Protection - 60V maximum

Environmental

• Temperature
  • Operation - -20 to +40°C
  • Non-operation - -25 to +65°C
• Humidity
  • Operation - 5 to 90%
• EMC
  • FCC Part 15 Class B
  • EN55022 Class B
• Isolation Test
  • Primary to Secondary - 4242 VDC for 1 minute, 10mA
  • Primary to Field Ground - 2121VDC for 1 minute, 10mA
  • Output to Field Ground - 2121VDC
• Immunity
  • ESD - EN61000-4-2. Level 3
  • RS - EN61000-4-3. Level 3
  • EFT - EN61000-4-4. Level 2
  • Surge - EN61000-4-5. Level 3
  • CS - EN61000-4-6. Level 2
  • Voltage Dips - EN61000-4-11
  • Harmonic - EN61000-3-2 Class A
• Insulation Resistance
  • Primary to Secondary - >10M OHM 500VDC
  • Primary to Field Ground - >10M OHM 500VDC
• Detection - Requires 25K detection on data pairs 3,6(+) 1,2(-) for full power 75W

Feature

• Over Voltage/Current, Short Circuit Protection - Outputs equipped with short circuit protection and overload protection. The output can be shorted permanently without damage.
• Indicators
  • Green LED 1 - DC Power “OK”
  • Red LED - Fault detected
  • Green LED 2 - Power detected “CONNECT” at 75W
• Input Connector - IEC320 inlet 3 pin
• Output PoE Connector - 4-pair powering Pins 3,6, 4,5(+) Pins 1,2, 7,8 (-)
• Warranty - 1 Year

POE75U-1UP-PD Specifications PDF