NV-8PS13-PVD NVT 8-Ch Power Supply Passive Receiver Hub

The 8-channel NV-8PS13-PVD is a key hybrid component that consolidates all CCTV system cabling using standard EIA/TIA 568B structured building wiring. Designed for installation in the IDF/Telecom Closet or MDF/Equipment Room, the Power Supply Passive Video Receiver Hub has independently selectable 24VAC-OFF-28VAC outputs that can support at-distance camera loads up to 1 Amp per channel. Use with NVT’s PVDTM transceivers for cable runs under 750ft (225m). A built-in passive receiver hub allows connection to DVR or an encoder for IP transmission. Per-channel diagnostic LEDs display load /no-load, miswires, or fault conditions at a glance. Automatic-reset fault protection, transient protection, and ground loop

Specifications

Video

• Frequency response - DC to 10 MHz
• Attenuation - 0.5 dB typ
• Common-mode / Differential-mode rejection
  • 15 KHz to 5 MHz - 60 dB typ
• Impedance
  • Coax, female BNC - 75 ohms
  • UTP, RJ45 - 100 ohms
• Network Wiring - One four-pair Cat5 or better per channel

Camera Power

• Each camera is powered by a fully isolated (floating) Class 2 SELV output, individually switchable 24VAC / OFF/ 28VAC at up to 1 Amp. Each output is individually thermistor protected.

Power Input

• Power inlet - IEC with molded power cord (included)
• Voltage - 115 / 230VAC
• Current - 2.5 / 1.25 Amps
• Protection - 5x20mm type T fuse 2.5Amp 250V
• Wattage - 250 Watts
• Heat
  • (power supply only) 100 BTU / Hour
  • (power supply with cameras) 900 BTU / Hour

Power Output

• Each camera is powered by a fully isolated (floating) Class 2 SELV ouput, individually switchable 24VAC / off / 28VAC at up to 1 Amp. Each output is individually thermistor protected for auto-reset after fault removal.

Front Panel Leds

• System Power - Blue LED
• Per-channel LED Indicates
  • Off - No load connected
  • Green - Load connected and working
  • Amber - Mis-wiring detected
  • Red - Overload fault condition

Environmental

• Ambient Temperature - -4 to +122 °F (-20 to +50 °C)
• Minimum airflow - 4ft 3 /min (0,1m 3 /min)
• Humidity (non-condensing) - 0 to 95%
• Transient Immunity - per ANSI / 587 C62.41

Mechanical

• Dimensions, including connectors
  • 19in wide, 1.73in high, 12in deep
  • 43cm wide, 4,5cm high, 20cm deep
• Weight - 14lb (6,35kg)

Accessories

• Mounting - Rack mount “L” brackets for front, rear, or wall installations;rubber feet for desk applications
• Cables - Eight 2ft (60cm) coax jumpers Molded IEC power inlet cord 7ft (200cm)

Optional Equipment

• Mounting
  • NV-RMBK2 Rear Mount Support Kit (designed for use with thinner metal equipment racks)
  • NV-WMBK2 Wall Mount Bracket Kit (heavy duty)

NV-8PS13-PVD Specifications PDF

NV-8PS13-PVD Installation Manual