E-37EV Seco-Larm 3-Zone Alarm Pager System

Specifications

Transmitter

• # of codes - Over 2 million (factory pre-set)
• Power - 12VDC
• RF output power - 4W max.
• Current drain
  • Standby - 10mA
  • Active - 1A
• Frequency - 27MHz
• Antenna impedance - 50 Ω
• Range - Up to 1/2 mile in open air1
• Dimensions - 41/8”x31/8”x15/16” (105x79x33 mm)
• Weight - 5.1-oz (145g)

Receiver

• # of codes - Learns up to 3 transmitter codes
• Power - 3VDC (2 AAA batteries)2
• Battery life - Approx. 1 month3
• Current drain
  • Standby - 1mAActive (Beep) - 20mA
  • Active (Vibrate) - 50mA
• Dimensions - 3”x21/8”x5/8” (76x54x16 mm)Weight - 1.6-oz (45g) (without battery)

Software

• Trigger Indication - Colored LEDs and beeps
• Transmitter Indication - ‘PAGE’ LED flashes Red, Green or Orange
• Positive Trigger Input
  • LED Indicator - 'ZONE' LED flashes Green
  • Audible Indicator - Beeps in groups of 9 for 1 minute
  • Vibration Indicator - Vibrates in groups of 9 for 1 minute
• Negative Trigger Input 1
  • LED Indicator - 'ZONE' LED flashes Red
  • Audible Indicator - Beeps in groups of 9 for 1 minute
  • Vibration Indicator - Vibrates in groups of 9 for 1 minute
• Negative Trigger Input 2
  • LED Indicator - 'ZONE' LED flashes Orange
  • Audible Indicator - Beeps in groups of 9 for 1 minute
  • Vibration Indicator - Vibrates in groups of 9 for 1 minute
• Manual Page
  • LED Indicator - 'ZONE' LED flashes Green
  • Audible Indicator - Beeps in 3 groups of 3 for 1 minute
  • Vibration Indicator - Vibrates in 3 groups of 3 for 1 minute
• Power ON
  • LED Indicator - 'ZONE' LED will not be lit
  • Audible Indicator - Beeps in 3 groups of 3 for 1 minute
  • Vibration Indicator - Vibrates in 3 groups of 3 for 1 minute
• Low Battery Indicator - Beep/vibrate twice every 60 seconds or when switch is pushed
• Memory Indicator - Three continuous beeps/vibrates if no signals or at the end of all signals Beep/vibrate if the signal is an alarm page, will not beep/vibrate for manual page
• Unattended Page Indicator - Beep/vibrate once every 30 seconds after initial signal is received. Will continue to beep until switch is pushed

E-37EV Specifications PDF

E-37EV Manual