[DISCONTINUED] 2GIG-DW10-120PK 2GIG Thin Door/Window Contact - 120 Pack

The Thin Door/Window Contact is designed for use on doors, windows, and other objects that open and close. It communicates with the control panel using the 345 MHz frequency. When the magnet (which is mounted near the sensor) moves away from or closer to the door contact’s sensor, signals are transmitted to the control panel.

The door contact also has an external input that accepts connections from normally-closed (NC) dry contact devices. For added protection, it is also equipped with a cover tamper.

Specifications

• Wireless Signal Range - 500 ft., open air, with 2GIG Wireless Alarm Control Panel
• Code Outputs - Alarm; Alarm Restore; External Alarm; External Restore; Tamper; Tamper Restore; Supervisory; Low Battery
• Transmitter Frequency - 345.000 MHz (crystal controlled)
• Transmitter Frequency - Tolerance ± 10 kHz
• Transmitter Bandwidth - 24 kHz
• Modulation Type - Amplitude Shift Keying—On/Off Keying (ASK-OOK)
• Unique ID Codes - Over one (1) million different code combinations
• Supervisory Interval - 70 minutes
• Peak Field Strength Typical - 36,000 uV/m at 3m
• External Input Sampling Current - 20 uA
• External Input - Accepts N/C dry contact devices
• Reed Switch Magnetic Sensitivity - 10 to 20 amp turns
• Reed Sensitivity - 0.625 in. (1.59 cm) minimum gap, 0.85 in. (2.16 cm) typical
• Magnet Type - Rare earth
• Magnet Dimensions (LxWxH) - 1.3 x 0.435 x 0.312 in. (3.3 x 1.1 x 0.79 cm)
• Sensor Dimensions (LxWxH) - 2.59 x 1.03 x 0.49 in. (6.58 x 2.62 x 1.24 cm)
• Weight (including battery & magnet) - 1.1 oz. (31.2 g)
• Housing Material - ABS plastic
• Color - White
• Operating Temperature - 32° to 120°F (0° to 49°C)
• Relative Humidity - 5-95% Non-Condensing
• Battery (included, not installed) - Two (2) Panasonic CR2032, 3 VDC, 225 mAh or equivalent Lithium coin batteries
• Battery Life - 5 years
• Regulatory Listing(s) - ETL, FCC Part 15, Industry Canada
• Warranty - Two (2) years
• Included Accessories - Two (2) Phillip’s flat-head screws, one (1) two-pin connector with a 12” flying 2-wire lead, adhesive strip