IME3122-1I Pelco 3-9mm Varifocal 30FPS @ 2048 x 1536 Indoor IR Day/Night WDR Dome IP Security Camera - PoE

Sarix Enhanced Range with SureVision Sarix Enhanced (E) range cameras feature SureVision technology, delivering high definition (HD) resolution, consistent color science, fast processing power, and simultaneous advanced low-light performance with wide dynamic range (WDR) and antibloom technologies. New advancements include 3D noise filtering, smooth response to illumination changes, and improved tone mapping to retain color accuracy and overall image contrast. Designed to install quickly, the cameras include autofocus, motorized zoom, built-in analytics, and other advanced features needed for demanding security applications.

Specifications

Camera

• Imaging Device- 1/3-inch
• Imager Type- CMOS
• Imager Readout- Progressive scan
• Highest Resolution
  • 3 MPx- 2048 x 1536
  • 2 MPx- 1920 x 1080
  • 1 MPx- 1280 x 1024
  • 0.5 MPx- 800 x 608
• Signal-to-Noise Ratio- >60 dB
• Electronic Shutter Range- 1 ~ 1/77,000 sec
• True Wide Dynamic Range- Up to 100 dB*
• White Balance Range- 2,000° to 10,000°K
• Sensitivity 3 ~ 9 mm- f/1.2; 2,850°K; SNR >20 dB
• Color (33 ms)- 0.2 lux
• Color (500 ms)- 0.005 lux
• Mono (33 ms)- 0.05 lux
• Mono (500 ms)- 0.0013 lux
• Sensitivity 9 ~ 22 mm- f/1.6; 2,850°K; SNR >20 dB
• Color (33 ms)- 0.4 lux
• Color (500 ms)- 0.009 lux
• Mono (33 ms)- 0.09 lux
• Mono (500 ms)- 0.002 lux
• Day/Night Capabilities- Yes
• Mechanical IR Cut Filter- Yes, (ON/OFF/AUTO selectable), with different set points on lux

LENS

• Lens Type- Built-in; varifocal
• Focal Length- f/1.2, 3 ~ 9 mm, or f/1.6, 9 ~ 22 mm
• Focus- Autofocus, motorized
• Zoom- Remote
• Auto Iris Type- DC drive P-iris lens

AUDIO

• Streaming- Bidirectional: full or half duplex
• Input/Output- Line level/external microphone input; 600-ohm differential, 1 Vp-p max. signal level; built-in microphone
• Compression- G.711 PCM 8 bit, 8 kHz mono at 64 kbit/s

VIDEO

• Video Streams- Multiple simultaneous streams with up to 2 different configurations plus service stream; the secondary stream is variable based on the setup of the primary stream
• Available Resolutions- Two configurable streams as follows:
• Frame Rate- Up to 30, 25, 15, 12.5, 10, 5, 1 (depending on the coding, resolution, and stream configuration)
• Video Encoding- H.264 High, Main, or Base profiles; and MJPEG
• Bit Rate Control- Constrained variable bit rate (CVBR), constant bit rate (CBR), and variable bit rate (VBR) with target range
• Service Stream- JPEG stream; the aspect ratio will be consistent with the independent streams

NETWORK

• Supported Protocols- TCP/IP, UDP/IP (Unicast, Multicast IGMP), UPnP, DNS, DHCP, RTP, RTSP, NTP, IPv4, IPv6, SNMP v2c/v3, QoS, HTTP, HTTPS, LDAP (client), SSH, SSL, SMTP, FTP, ARP, ICMP, and 802.1x (EAP)
• Users
  • Unicast- Up to 20 simultaneous users depending on the resolution settings
  • Multicast- Unlimited users H.264
• Security Access- Password protected
• Software Interface- Web browser view and setup

ELECTRICAL

• Network Port- RJ-45 connector for 100dBase-TX Auto MDI/MDI-X
• Accessory Port- Micro B USB connector for Pelco accessories
• Cable Type- Cat5 or better for 100dBase-TX
• Input Power- PoE (IEEE 802.3af, Class 3)
• Power Consumption†- 8.5 W nominal
• Current Consumption- 350 mA maximum
• Local Storage- Micro SD
• Alarm
  • Unsupervised- Detects open or closed alarm state
  • Supervised- Detects open and short alarm state with external 1-kohm resistor
• Input- 3.5 VDC maximum, 3.5 mA maximum
• Relay Output- ±32 VDC maximum, 150 mA maximum

MECHANICAL

• Dome Attenuation
  • Clear- f/0.0 light loss
  • Smoked- f/1.0 light loss
• Pan/Tilt Adjustment- Manual
• Pan- 355°
• Tilt- 180°
• Rotation- 360°

ENVIRONMENTAL

• Operating Temperature
  • Indoor/Vandal-Resistant- –10° to 50°C (14° to 122°F)
  • Environmental- –40° to 50°C (–40° to 122°F)
• Cold Start
  • Indoor/Vandal-Resistant- –10°C (14°F)
  • Environmental- –20°C (–4°F)
  • Storage Temperature- –10° to 60°C (14° to 140°F)
• Operating Humidity
  • Indoor/Vandal-Resistant- 20 to 80%, RH noncondensing
  • Environmental- 10 to 95%, RH condensing
  • Storage Humidity- 20 to 80%, RH noncondensing
• Impact Resistance- K10++ (50J) per IEC 62262 (environmental/ vandal-resistant models)
• Shock and Vibration- EN50155 Category 1, Class B; IEC 60068:2-6 and 2-27 (environmental/vandal-resistant models)

IME3122-1I Specifications PDF