POE75U-1UP Pelco 75W HPOE Single Port Injector No Pwr Crd

The POE75U-1UP Power over Ethernet (PoE) single port power injector is designed to meet the demanding data rate and power requirements of outdoor Spectra Enhanced IP cameras with high-quality streaming video capabilities. The injector offers total output power of 75 W, which meets the IEEE802.3af and IEEE802.3at standards for detection, connection, disconnection, and fault protection. The POE75U-1UP power injector is compatible with 10/100/ 1000Base-T systems. AC input voltage ranges from 100 to 240 VAC with input frequency from 47 to 63 Hz. Maximum output load current is 350 mA at 56 VDC..

Specifications

ELECTRICAL

• Input Voltage Rating - 100 to 240 VAC
• AC Input Current - 2 A (RMS) maximum for 90 VAC;1.2 A (RMS) maximum for 240 VAC
• Leakage Current - 3.5 mA maximum at 254 VAC 60 Hz
• AC Input Frequency - 47 to 63 Hz
• AC Inrush Current - 30 A (RMS) maximum for 115 VAC; 60 A (RMS) maximum for 230 VAC
• Total Output Power - 75 W
• Ripple and Regulation - 250 mV maximum
• Efficiency - 80% (typical) at maximum load; 120 VAC, 60 Hz
• Hold-up Time - 10 milliseconds minimum; 120 VAC and maximum load
• Transient O/P Voltage Protection - 60 V maximum at switch; on and off at any AC line phase
• Over Voltage/Current, Short Circuit Protection - Outputs equipped with short circuit protection and overload protection according to IEEE802.3af specification; the output can be shorted permanently without damage
• Input Connectors - IEC320 inlet 3-pin
• Output Connection - 4-pair powering for full power; 2-pair powering for IEEE802.3at mode
• IEEE 802.3af/at Interoperability - If 25 kohm is detected the unit operates in IEEE802.3at mode; 33.6 W, 2 pair powering; 12.5 k detection resistance required for full power

ENVIRONMENTAL

• Operating Temperature - –20° to 40°C (–4° to 104°F)
• Storage Temperature - –25° to 65°C (–13° to 149°F)
• Maximum Humidity Gradient - 5% to 90%

POE75U-1UP Specifications PDF