ES6230-12-R2 Pelco 4.5-129mm 30x Optical Zoom 1920 x 1080 Outdoor IR Day/Night WDR PTZ 48VDC with Wiper

Pelco’s iconic Esprit Series positioning system provides best-in-class image quality and pan/tilt performance. Esprit Enhanced provides the total package of impressive image quality, valuable software features, and time-tested pan/tilt performance suitable for any installation environment.

Specifications

Camera/Optics

• Sensor Type - 1/2.8-inch Type Exmor CMOS Sensor
• Optical Zoom - 30X
• Digital Zoom - 12X
• Maximum Resolution - 1920 x 1080
• Lens - f/1.6 ~ f/4.7, focal length 4.3 mm (wide) ~ 129.0 mm (tele)
• Horizontal Angle of View - 63.7°(wide) - 2.3° (tele)
• Aspect Ratio - 16:09
• Light Sensitivity
  • Color (33 ms) - 0.03 lux
  • Color (250 ms) - 0.008 lux
  • Mono (33 ms) - 0.004 lux
  • Mono (250 ms) - 0.001 lux
• Day/Night Capabilities - Yes
• Shutter Range - 1/1 ~ 1/10,000 sec
• Signal-to-Noise Ratio - >50dB
• IR Cut Filter - Yes
• Wide Dynamic Range - 130 dB
• Iris Control - Auto iris with manual override
• Backlight Compensation - Yes
• Automatic Gain Control - Yes
• Active Noise Filtering - 3D Noise Filtering
• Electronic Image Stabilization (EIS) - Yes
• IR Wavelength - 850nm

Video

• Video Encoding - H.264 High, Main, or Base profiles and MJPEG
• Video Streams - Up to 2 simultaneous streams; the second stream is variable based on the setup of the primary stream
• Frame Rate - Up to 60, 50, 30, 25, 15, 12.5, 10, 8.333, 7.5, 6, 5, 3, 2.5, 2, 1 (depending on the coding, resolution, and stream configuration)
• Available Resolutions
  • Resolution
    • MPx - 2.07, 0.92, 0.36, 0.23, 1.23, 0.49, 0.31, 0.08
    • Width - 1920, 1280, 800, 640, 320
    • Height - 1080, 720, 448, 352, 960, 608, 480, 240
    • Aspect Ratio - 16:9, 4:3
  • H.264 High Profile (IP GOP structure)
    • Maximum IPS - 60, 30
    • Recommended Bit Rate (Mbps) - 8, 6.05, 3, 2, 1.8, 3.8, 1.45, 0.5

Network

• Interface
  • Ethernet (100Base-TX)
  • Auto MDI/MDI-X
  • Auto-Negotiate
• Ethernet Cabling Type - Cat5e or better
• SFP Interface - Supports SFP Transceivers
• Supported Protocols - TCP/IP, UDP/IP (Unicast, Multicast IGMP), UPnP, DNS, DHCP, RTP, RTSP, NTP, IPv4, IPv6*, SNMP v2c/v3, QoS, HTTP, HTTPS, SSH, SSL, SMTP, FTP, and 802.1x (EAP), NTCIP 1205
• Users
  • Unicast - Up to 20 simultaneous users depending on resolution settings (2 guaranteed streams)
  • Multicast - Unlimited users H.264
• Security Access - Password protected, 802.1x, HTTPS
• Software Interface - Web browser view and setup
• Pelco System Integration
  • VideoXpert Enterprise and VideoXpert 2.0 or later
  • Endura 2.0 (or later)
  • Digital Sentry 7.3 (or later)
• Open API - Pelco API or ONVIF Profile S, Profile G, and Profile Q
• Mobile Application - Integrated to Pelco Mobile App
• Video Motion Detection - Simple motion detection and camera sabotage
• Local Storage - Capture 1–5–10 second video clips on camera sabotage, motion detection, or alarm input; record video continuously in the case of network outage with option to overwrite; access video through FTP protocol and ONVIF Profile G
• SDXC Card - Addressable up to 2TB

Minimum System Requirements

• Processor - Intel Core i3 Processor, 2.4 GHz
• Operating System - Windows 7 (32-bit and 64-bit) with DirectX 11, Windows XP Service Pack 3 with DirectX 9.0c, or Mac OS X 10.4 (or later)
• Memory - 4 GB RAM
• Network Interface Card - 100 megabits (or greater)
• Monitor - Minimum of 1024 x 768 resolution, 16- or 32-bit pixel color resolution
• Web Browser - Internet Explorer 10.0 (or later) or Firefox 3.5 (or later); Internet Explorer 8.0 (or later) is recommended for configuring analytics

Analytics

• Required Systems for Pelco Analytics
  • Pelco Interface
    • VideoXpert Enterprise and VideoXpert Pro 2.0 or later
    • WS5200 Advanced System Management Software on an Endura 2.0 (or later) system
  • Open API - The Pelco API can transmit behavior alarm data to third-party applications, available at pdn.pelco.com. ONVIF Analytic Service Support for Analytic Events.

General

• Construction - Die-cast, extruded and sheet aluminum; stainless steel hardware
• Finish - Gray polyester powder coat
• Operating Temperature - –45° to 60°C (–50° to 140°F) ambient for sustained system operation or 74°C (165.2°F) absolute maximum ambient per NEMA TS-2; within two hours after power-up, the entire unit can de-ice and be operational from a temperature of –25°C (–13°F). Cold start from –40°C.
• Wind
  • Full Motion Control - 0 to 65 knots (75 mph/120 kph)
  • Limited Speed Control - 65 to 78 knots (90 mph/145 kph)
  • Survive* - 78 to 130 knots (150 mph/240 kph) (*Without sun shield)
• Storage Temperature - –20° to 60°C (–4° to 140°F)
• Operating Humidity Unit
  • Standard with IOP: 10 to 90% relative humidity (noncondensing)
  • Standard with IOC: 10 to 100% relative humidity (condensing)
• Effective Projected Area
  • Without IR - 193 inch^2
  • With IR - 243 inch^2

Pressurized Integrated Optics Cartridge (Ioc)

• Pressurized to 10 psig, Nominal (Sea Level, 21^ºC [70^ºF])
• Internal Sensor for Pressure Reading
• Designed to IP66 Standards
• U.S. Patent D472,260

Mechanical

• Variable Speed - 0.1° to 140°
• Preset Accuracy - ±0.1°
• Pan Movement - 360° continuous pan rotation
• Vertical Tilt - Unobstructed +40° to –90°
• Manual Pan/Tilt Speeds
  • Pan - 0.1° to 80°/sec
  • Tilt - 0.1° to 40°/sec
• Preset Speeds - 140°/sec

Electrical

• Input Voltage
  • HPoE, 24 VAC, 48 VDC
  • Mains 100 to 240 VAC
• Input Voltage Range - ±10%
• Max Power Consumption
  • 24 VAC - 72 VA
  • HPoE - 72 VA (HPoE 802.3bt Class 8 compliant)
  • 48 VDC - 72 VA / 110 VA
  • Mains - 72 VA / 110 VA
• Heater and Defroster - Thermostatically controlled
• Electrical Connections
  • 24 VAC, 48 VDC, 100 to 240 VAC
  • Screw terminals for power
• Alarms - Four; Detects open or closed alarm state
• Input - 3.5 VDC maximum, 3.5 mA maximum
• Unsupervised - Detects open or closed alarm state
• Supervised - Detects open and short alarm state with external 1k-ohm resistor
• Relay Outputs - Two; 30 VDC maximum, 1A maximum

Audio

• Input/Output - Line level/external microphone input; 600-ohm differential, 1Vp-p maximum signal level
• Streaming - Embedded audio

Certifications/ratings

• CE, Class A
• FCC, Class A
• KCC
• UL/cUL Listed
• C-Tick
• NEMA TS-2 (Temp.) para 2.2.7.3 - 2.2.7.7
• Meets NEMA Type 4X and IP66 Standards
• ONVIF Profile S
• ONVIF Profile G
• ONVIF Profile Q
• Shock test per IEC 60068-2-27 Ea
• Cisco Medianet Media Services Proxy 2.0 compatible
• Vibration per IEC60068-2-6 Fc
• Shock test per IEC 60068-2-27 Ea

ES6230-12-R2 Specifications PDF