EFLOW6NA8DR Altronix Eight 8 PTC Outputs Power Supply/Charger with Multi-Output Access Power Controllers - Red

eFlow6NA8D distributes and switches power to access control systems and accessories. It converts a 120VAC 60Hz input into eight (8) independently controlled 12VDC or 24VDC PTC protected outputs. These power outputs can be converted to dry form "C" contacts. Outputs are activated by an open collector sink or normally open (NO) dry trigger input from an Access Control System, Card Reader, Keypad, Push Button, PIR, etc. Unit will route power to a variety of access control hardware devices including: Mag Locks, Electric Strikes, Magnetic Door Holders, etc.

Specifications

Input

• Voltage - 120VAC, 60Hz.
• Input Fuse - Varies, see Reference Chart.

Outputs

• Class 2 Rated power-limited PTC Protected Outputs (auto-resettable).
• Voltage - 12VDC or 24VDC, see Reference Chart.
• Current - Varies, depending on the model.
• Protection - PTC 2.0A.2A.
• Auxiliary - 3.5A (unswitched).
• Other- Overvoltage protection.Filtered and regulated.

Back-up Battery (not included)

• Capacity - 12AH / 12VDC (1 or 2 within enclosure).18AH / 40 AH / 65 AH(requires separate enclosure).
• Type - Sealed lead acid or gel type.
• Fuse Rating - Varies, see Reference Chart.
• Failover - Upon AC loss, instantaneous.

Fire Alarm Disconnect

• Supervised - Latching or non-latching, individually selectable for any or all of the eight (8) outputs.
• EOL - 10K Resistor.

Supervision

• AC Failure - Form "C" contacts.
• Battery - Form “C" contacts.
• Low DC Power Shutdown - Shuts down DC output terminals if battery voltage drops below 71-73% for 12V units and 70-75% for 24V units (depending on the power supply). Prevents deep battery discharge.

Indicators (LED)

• Input - 120VAC is present.
• DC Output - Powered.
• Relays - Individual LEDs indicate outputs are triggered (relays energized).
• FACP - Indicates FACP disconnect is triggered.

Agency Listings

• UL - UL294 - Access Control System Units.
• cUL - ULC-S319-05 - Electronic Access Control Systems.Class I Equipment; CSA C22.2 No.205 - Signal Equipment
• CSFM - California State Fire Marshall Approved.
• CE - European Conformity

Physical and Environmental

• Dimensions (H x W x D) - 15.5" x 12" x 4.5" (393.7mm x 304.8mm x 114.3mm).
• Product Weight - 8.6 lbs. (3.9 kg)
• Shipping Weight - 9.9 lbs. (4.49 kg)
• Operating temperature - 0°C to 49°C (32°F to 120°F).
• Storage temperature - -20°C to 70°C (-4°F to 158°F).
• Relative Humidity - 85% +/-5%
• BTU/Hr (approx.)12VDC - 37 BTU/Hr, 24VDC - 74 BTU/Hr.

EFLOW6NA8D Specifications PDF

EFLOW6NA8DR Installation Manual