RGA150B-F8Z/T8-A LifeSafety Power ProWire AMAG 8 Door 4 Amp 12VDC and 24VDC 8 FAI Control Access Control Power Supply in UL Listed Indoor 19" W x 3.5" H x 20.5" D Rackmount Electrical Enclosure

These ProWire Unified Power rack mount models are single and dual voltage access power systems, precision wired for AMAG controllers. ProWire enables the specification and installation of standardized access power equipment across an enterprise for uniform operation, maintenance and servicing.

The F8 egress output module provides eight outputs selectable for constant output, enable on FAI, or disable on FAI. Each output is selectable for either 12 or 24V in dual voltage systems.

The D8 provides eight auxiliary outputs, individually selectable for 12 or 24V in dual voltage systems.

Specifications

Power Supplies

• FPO150 Power supply board, 4A/24V
• B100 Secondard voltage module, 4A/12V class 2 power limited
• Input 120/230VAC 50/60Hz | 83 Watts (0.69A)
• Overload and short circuit protection
• Over temperature protection
• Polarized AC power supply disconnect

Battery Charging

• Independent built-in charger for sealed lead-acid or gel type batteries
• Microprocessor dual rate charging of 12 or 24V battery sets
• Automatic switchover to standby battery when AC fails
• Zero voltage drop when switched over to battery backup

Supervision

• AC Fault (form "C" contacts)
• System Fault (form "C" contacts)
• System Fault conditions: Low or no battery | short to earth ground | power supply failure

Distribution Modules

• F8 8 egress outputs, fused at 3A per output

Enclosures

• Size - 2U rack mount (19.00"W x 3.50"H x 20.50"D)
• Weight - 24 lbs.
• Z bracket wire management articulating arm

Wiring Suffix

• T8-A - T = Tie Wrap, 8 = Door Count, A = M2150

Regulatory Compliance

• UL / ULC - UL294, ULC S319
• CSA / FCC - CSA C22.2 #107.1 | FCC Part 15, CSFM

RGA150B-F8Z/T8-A Specifications PDF