MAXIMAL7FAMZ Altronix 1 Channel 10Amp 24VDC Power Supply in UL Listed NEMA 1 Indoor 19” W x 26” H x 6.25” D Steel Electrical Enclosure

eFlow104NB Specifications

Input

• Voltage - 120VAC, 60Hz, 4.5A max
• Fusing - 6.3A / 250V

Output

• Voltage - 24VDC
• Current - 10A continuous max
• Auxiliary - Power-limited @ 1A (unswitched)
• Other - Overvoltage protection. Filtered and regulated outputs

Back-up Battery (not included)

• Type - Sealed lead acid or gel type
• Fuse Rating - 15A @ 32VDC
• Failover - Upon AC loss, instantaneous

Fire Alarm Disconnect

• Supervised - Latching or non-latching
• EOL - 10K Resistor

Supervision

• AC Failure - Form “C” contacts
• Battery - Form “C” contacts
• Low DC Power Shutdown - Shuts down DC output terminals if battery voltage drops below 71-73% for 12V units and 70-75% for 24V units (depending on the power supply). Prevents deep battery discharge

Indicators (LED)

• Input - 120VAC is present
• DC Output - Powered

Agency Listings

UL

• Access Control - UL294
• Burglar Alarm - UL603
• Fire Alarm - UL1481

cUL

• Burglar Alarm - ULC-S318-96
• Access Control - ULC-S319-05
• Signal Equipment - CSA C22.2 No.205

Physical and Environmental

• Dimensions (H x W x D) - 8.25” x 4.56” x 1.5” (209.5 mm x 115.8 mm x 38.1 mm)
• Product Weight - 1.1 lbs. (0.5 kg)
• Shipping Weight - 1.25 lbs. (0.57 kg)
• Operating Temperature - 0ºC to 49ºC (32ºF to 120ºF)
• Storage Temperature - -20ºC to 70ºC (-4ºF to 158ºF)
• Relative Humidity - 85% +/-5%
• BTU/Hr. (approx.) - 123 BTU/Hr

ACM8CB Specifications

Input

• Voltage
  • 12 to 24 VAC or VDC operation (setting not required), 0.6A @ 12V, 0.3A @ 24V current consumption with all relays energized
  • Main fuse is rated at 10A
• Trigger Inputs
  • Eight (8) Access Control System trigger inputs
  • a) Eight (8) normally open (NO) inputs
  • b) Eight (8) open collector sink inputs
  • c) Any combination of the above
• Input Options
  • a) One (1) common power input (board and lock power)
  • b) Two (2) isolated power inputs (one (1) for board power and one (1) for lock/accessory power)
• Outputs
  • Eight (8) independently controlled Class 2 Rated PTC protected power-limited auto-resettable 2.5A outputs
  • a) Eight (8) Fail-Safe and/or Fail-Secure power outputs. Eight (8) auxiliary power outputs (unswitched)
• Output ratings
  • Output PTCs are rated 2.5A each
  • Note - Total output current is determined by the power supply, not to exceed a maximum of 10A total

Indicators (LED)

• Red LEDs - Outputs are triggered (relays energized)
• Green LED - FACP disconnect is triggered

Agency Listings

• UL - UL294 : Access Control System Units
• cUL: - CSA Standard C22.2 : General Signaling Equipment
• No.205-M1983

Physical and Environmental

• Dimensions (H x W x D) - 8” x 4” x 0.75” (203.2mm x 114.3mm x 19.1mm)
• Product Weight - 0.65 lbs. (0.29 kg)
• Shipping Weight - 0.85 lbs. (0.39 kg)
• Operating Temperature - 0ºC to 49ºC (32ºF to 120ºF)
• Storage Temperature - -20ºC to 70ºC (-4ºF to 158ºF)
• Relative Humidity - 85% +/-5%
• BTU/Hr. (approx.) - 4 BTU/Hr

ACM4CB Specifications

Input

• Voltage
  • 12 to 24 VAC or VDC operation (setting not required), 0.4A @ 12V, 0.2A @ 24V current consumption with all relays energized
  • Main fuse is rated at 10A
• Trigger Inputs
  • Four (4) Access Control System trigger inputs
  • a) Four (4) normally open (NO) inputs
  • b) Four (4) open collector sink inputs
  • c) Any combination of the above
• Input Options
  • a) One (1) common power input (board and lock power)
  • b) Two (2) isolated power inputs (one (1) for board power and one (1) for lock/accessory power)
• Outputs
  • Four (4) independently controlled Class 2 Rated PTC protected power-limited auto-resettable 2A outputs
  • a) Four (4) Fail-Safe and/or Fail-Secure power outputs. Four (4) auxiliary power outputs (unswitched)
• Output ratings
  • Output PTCs are rated 2A each
  • Note - Total output current is determined by the power supply, not to exceed a maximum of 10A total

Indicators (LED)

• Red LEDs - Outputs are triggered (relays energized)
• Green LED - FACP disconnect is triggered

Agency Listings

• UL - Access Control : UL294
• cUL: - General Signaling Equipment Equipment Evaluated to CSA Standard C22.2 No.205-M1983

Physical and Environmental

• Dimensions (W x L x H) - 5.175” x 3.36” x 1.25” (131.4mm x 85.3mm x 31.8mm).
• Product Weight - 0.35 lbs. (0.16 kg)
• Shipping Weight - 0.45 lbs. (0.2 kg)
• Operating Temperature - 0ºC to 49ºC (32ºF to 120ºF)
• Storage Temperature - -20ºC to 70ºC (-4ºF to 158ºF)
• Relative Humidity - 85% +/-5%
• BTU/Hr. (approx.) - 12VAC or VDC: 2 BTU/Hr., 24VAC or VDC: 3 BTU/Hr

EFLOW104NB Specifications PDF

ACM8CB Specifications PDF

ACM4CB Specifications PDF