NV-4PS13-PVD NVT 4 Channel Power Supply Passive Receiver Hub

The 4-channel NV-4PS13-PVD is a key hybrid component that consolidates all CCTV system cabling using standard EIA/TIA 568B structured building wiring. Designed for installation in the IDF/Telecom Closet or MDF/Equipment Room, the Power Supply Passive Video Receiver Hub has independently selectable 24VAC-OFF-28VAC outputs that can support at-distance camera loads up to 1 Amp per channel. Use with NVT’s PVDTM transceivers for cable runs under 750ft (225m). A built-in passive receiver hub allows connection to DVR or an encoder for IP transmission. Per-channel diagnostic LEDs display load no-load, miswires, or fault conditions at a glance. Automatic-reset fault protection, transient protection, and ground loop free individually floating outputs.

Specifications

• Wire Distance - Supply voltage, wire resistance and minimum camera operating voltage determine the maximum camera distance.
• Video
  • Frequency response - DC to 5 MHz
  • Attenuation - 0.5 dB typ
  • Common-mode / Differential-mode rejection
    • 15 KHz to 5 MHz - 60 dB typ
  • Impedance
    • Coax, female BNC - 75 ohms
    • UTP, RJ45 - 100 ohms
  • Network Wiring - One four-pair Cat5 or better per channel
• Camera Power - Each camera is powered by a fully isolated (floating) Class 2 SELV output, individually switchable 24VAC / OFF/ 28VAC at up to 1 Amp. Each output is individually thermistor protected.
• Power Input
  • Power inlet - IEC with molded power cord (included)
  • On-off switch - Rear panel
  • Voltage - 115 / 230 VAC
  • Current - 1.25 / 0.625 Amps
  • Frequency - 50 / 60 Hz
  • Protection - 2.5A slo-blo 8x20mm fuse and thermal shutdown
  • Wattage - 125 Watts
  • Heat
    • (power supply only) 50 BTU/hour
    • (power supply with cameras) 420 BTU/hour
• Front-Panel LEDs
  • Blue LED - System Power On
  • Per-channel LED indicates
    • Off - No load connected
    • Green - Load connected & working
    • Amber - Mis-wiring detected
    • Red - Overload shutdown condition
• Environmental
  • Ambient Temperature - 0 to +140°F (-20 to +50°C)
  • Minimum airflow - 4 ft3 / min (0.1 m3 / min)
  • Humidity (non-condensing) - 0 to 95%
  • Transient Immunity - per ANSI 587 C62.41
• Mechanical
  • Dimensions, including connectors
    • 9.25in wide, 1.75in high, 7.25 in deep
    • 235mm wide, 44.5 mm high, 184 mm deep
  • Weight - 7 lb (3.2 kg)
  • Mounting - Wall, or desk mount

NV-4PS13-PVD Specifications PDF