FMD2-4 PulseWorx Fixture Module - Dimming, 2 Channels, 400W Max

The FMD Fixture Module Dimmer is a two channel wire-in home automation light dimmer which is capable of receiving UPB digital commands over the existing powerlines.
The FMD is the ideal solution to controlling incandescent lights or fixtures that are not currently wired to a dedicated wall switch location or need to be individually controlled.
With two separate control channels, the FMD is perfect for certain ceiling fans with lights combinations and provides as much as 400W of power split between the two channels.

Specifications

ELECTRICAL

• Power Requirements- Primary: 120 Volts AC, 50/60Hz
• Transmission Channels- 2 Channels
• Max. Loading- 400W max. or 200W split between each channel
• Connections/Power Wire-
  • 16 AWG gauge 105 C insulation
  • Black – Hot/Line
  • White – Neutral
  • Red - Load (channel 1)
  • Yellow - Load (channel 2)
• Environmental Conditions-
  • Indoor Use Only
  • Temperature: -40° to 104°F (-40° to 40°C)
  • Humidity: 10% to 90% RH (non-condensing)

OPERATION

• Status LED Modes- All programmable with UPStart On, Opposite, Off, N/C
• LED Indicators- One per button; LED reflects status of Group
• IR Receiver - No
• During Power outage- Retains all settings in Non-volatile EERPOM
• Set-Up Mode - Press the setup button 5 times

MECHANICAL

• Mounting- Single Gang junction box or 1/2" Knockout
• Dimensions- Height: 2.87 in Width: 1.65 in Depth: 1.78 in
• Weight- 4.0 oz.
• Warranty- 5 years