XPW713 PulseWorx X-10 to UPB Converter, Converts X-10 from the powerline into UPB

The XPW713 X-10 to UPB Converter is a small plug-in electronic device that converts standard X-10 formatted messages sent on the AC powerline into corresponding UPB Communication Packets to control your PulseWorx UPB devices.
The XPW713 is the ideal solution for interfacing X-10 compatible transmitting devices and sensors to the high reliability of the UPB PulseWorx Lighting Control System.
The XPW713 receives X-10 messages on the existing AC powerline.

Specificatioins

ELECTRICAL

• Power Requirements - Primary: 120 Volts AC, 50/60Hz
• Environmental Conditions
  • Indoor Use Only
  • Temperature: -40° to 104°F (-40° to 40°C)
  • Humidity: 10% to 90% RH (non-condensing)

OPERATION

• Status LED Modes - All programmable with UPStart On, Opposite, Off, N/C
• LED Indicators - One per button; LED reflects status of Group
• During Power outage - Retains all settings in Non-volatile EERPOM
• Set-Up Mode - Press the setup button 5 times, the LED blinks

MECHANICAL

• Dimensions - Height: 3.00 in Width: 2.00 in Depth: 1.25 in
• Weight - 5.0 oz.
• Warranty - 5 years