VHW-HWPS-C Veracity Highwire Powerstar Ethernet & PoE Over Coax Camera Unit

HIGHWIRE Powerstar uses existing coax cable to connect and power IP cameras without cabling costs. Easy to use and fast to install.

Specifications

• Unit power - 1.5 watts
• BASE POE In - IEEE 802.3af (POE) or IEEE 802.3at (POE Plus), 2-event, power class 4
• Camera POE Out - IEEE 802.3af (POE) or IEEE 802.3at (POE Plus)
• DC Power input - 40-57 volts, 0.7 amps maximum, class 2 isolated, detachable screw terminal

• Connector - BNC 75ohm
• Cable Type - Any 75 Ohm coaxial (other impedances supported)
• Range - Up to 300m [1100ft] on RG59, 500m on RG11 [1600ft] at full rate
• Bandwith - 200Mbps (total up + down)

• Connector type - RJ45
• Cable type - Patch or crossover, auto-detected
• Rate - 100Base-TX, full duplex with auto negotiation

• Status indicators
• HIGHWIRE coax link
• Ethernet link/activity (BASE)
• Ethernet link/activity (CAMERA)
• POE-over-coax
• POE to camera
• Power available (5/10/15/20/25W)
• Colours - Off - Disabled. Green - Enabled. Red - Fault

• Dimensions - L 104mm W 54mm H 24mm (84mm excluding connector)
• Weight - 140g [5oz]
• Operating temperature
• -10ºC to 50ºC [14ºF to 122ºF] (delivering POE <15w)
• -10ºC to 40ºC [14ºF to 104ºF] (delivering POE Plus >15w)
• Relative humidity - 85% non-condensing
• Compliance - FCC, CE, RoHS

• VHW-HWPS-C - HIGHWIRE Powerstar Camera unit, for installation at the camera side Features POE-over-Coax or 57V DC power input & 802.3af/802.3at POE output

VHW-HWPS-C Specifications PDF

VHW-HWPS-C Manual