HTA125A Bogen Power Amplifiers

Specifications

• Rated Output Power - HTA125A - 125W
• Total Harmonic Distortion - Less than 0.5%, 20 to 20,000 Hz at full rated output
• Frequency Response - ±1 dB, 20 to 20,000 Hz at full rated output
• Input Sensitivity - Hi-Z, 500mV; Lo-Z balanced, with optional transformer,150mV
• Hum and Noise - 90 dB below rated output
• Output Loads - 4 ohms, 8 ohms, 25V, 25VCT, 70V
• Output Regulation - Better than 2 dB from no load to full load
• Input Impedances - Hi-Z, 50k ohms unbalanced; Lo-Z, 600 ohms, balanced or unbalanced, and 1:1 bridging with optional plug-in transformers
• Low-Cut Filter - -10 dB @ 100 Hz
• Controls & Indicators
  • Front Panel - Illuminated On/Off power switch and overload shutdown LED
  • Rear Panel - Input level control, Slo-Blo fuse
  • Internal - Low-Cut filter switch
• Power Requirements - HTA125A - 120V~, 60 Hz, 3.1A, 260 watts @ Full Rated Output (Idle 45W)
• Thermal Emissions (full power) - HTA125A - 426.9 BTU/hr.
• Overload Protection
  • Electronic overload protection
    • Electrical - HTA125A - 4A Slo-Blo Fuse
    • Thermal - Thermostat
• Auxiliary Receptacle (not switched) - Three-wire grounded*, 300 watts maximum
• Dimensions (without removable feet) - 19" W x 5-1/4" H x 11" D (48.3 x 13.3 x 27.9 cm)
• Front Panel Dimensions - 19" W x 5-1/4" H (48.3 x 13.3 cm)
• Finish - Black
• Product Weight - HTA125A - 36 lb. (16.3 kg)
• Regulatory Approvals - Listed to UL Standard 60065 for US and Canada
• Accessories - Model TL600, 600-ohm line-matching transformer; Model TL100, 1:1 line-matching transformer

HTA125A Specifications PDF

HTA125A Installation Manual