POE1AT-US Pelco Single-Port IEEE802.3at Midspan

Features

• Fully 802.3at Compliant Detection, Disconnect, Over Voltage, and Current Protection
  
• 30 W Output
  
• Full Protection
  
  • Over Current Protection (OCP)
    
  • Over Voltage Protection (OVP)
    
• Diagnostic LEDs
  
• Gigabit Compatibility
  
• Nonvented Case
  

Specifications

ELECTRICAL

• Input
  
  • Input Voltage Rating 90 to 264 VAC
    
  • AC Input Current
    • 0.8 A (RMS) maximum at 120 VAC;
      
    • 0.55 A (RMS) maximum at 240 VAC
      
  • Leakage Current 350 μA maximum
    
  • AC Input Frequency 47 to 63 Hz
    
  • AC Inrush Current 60 A maximum at 240 VAC and maximum load
    
• Output
  
  • Output Power 30 W
    
  • Efficiency 80% (typical) at maximum load; 120 VAC, 60 Hz
    
  • Hold-Up Time 10 milliseconds minimum; 120 VAC, 60 Hz and maximum load
    
  • Transient O/P Voltage
    
  • Protection 60 V maximum at switch on and off at any AC line phase
    
  • Isolation (HI-POT) Primary to Secondary:1,500 VAC for 1 minute, 10 mA
    
  • Insulation Resistance Primary to Secondary: >10 Mohm at 500 VDC
    
  • Over Voltage/Current, Short Circuit Protection The output is equipped with short-circuit protection and overload protection according to the IEEE802.3at specification and conforms to UL60950-2; the output can be shorted permanently without damage
    
• Connection
  
  • AC Input Connector IEC320 inlet 3-pin (C14)
    
  • Output Connection
    
    • +pins 3, 6
      
    • –pins 1, 2
      
  • Data IN/OUT Connector RJ-45

ENVIRONMENTAL

• Operating Temperature 0° to 40°C (32° to 104°F)
  
• Storage Temperature –25° to 65°C (–13° to 149°F)
  
• Maximum Humidity Gradient 5% to 90%
  
• Immunity
  
  • ESD EN61000-4-2, Level 3
    
  • RS EN61000-4-3, Level 3
    
  • EFT/Burst EN61000-4-4, Level 2
    
  • Surge EN61000-4-5, Level 3
    
  • CS EN61000-4-6, Level 3
    
  • Voltage Dips EN61000-4-11
    
  • Harmonic EN61000-3-2 Class A

POE1AT-US Spec Sheet