MYQ-888LM Alarm.com LiftMaster Control Panel Only

Specifications

• Disconnect all electrical power to the garage door opener.
• Remove the existing door control from the wall. Note the polarity of the wires connected to the existing door control. Label the wires appropriately (Red/White).
• Disconnect the wires from the existing door control.
• Connect the wires to the new MyQ Control Panel.
• Mount the MyQ Control Panel to the wall.
• Reconnect power. The yellow command LED (in the center of the MyQ Control Panel) and the red learn LED (above the learn button) will blink quickly for up to 5 minutes as the MyQ Control Panel recharges. When the MyQ Control Panel is operational, the yellow command LED will glow steadily.
• Test the MyQ Control Panel. Press the push bar to activate the garage door opener.
• Connect to LiftMaster Internet Gateway (See instructions below).

MYQ-888LM Specifications PDF