LD-ACC-WH Seco-Larm Wire Harness for Loop Detector

The LD-1123-PAQ Loop Detector is designed to be used with gates or other vehicle detection systems. The unit connected to an input loop which is buried in the pavement. If a vehicle is over the input loop, the detector sends a signal to perform such actions as opening a gate, holding a gate open, or indicating that a vehicle is in a bay.

Specifications

• Operating voltage - 12~24 VAC/VDC
• Current draw
  • Standby - 40mA@12VDC / 40mA@24VDC
  • Active - 50mA@12VDC / 60mA@24VDC
• Loop induction range - 80~300 μH
• Sensitivity - 3 levels of sensitivity
• Reaction time - 100ms
• Vehicle detection mode - Combines relays #1 and #2 to detect vehicle presence, with pulse on entry
• Presence output - Temporary (triggers relay #1 as long as vehicle is in the loop, times out after 5 minutes)
• Pulse output - Pulses relay #2 on entry
• Fault output - Relay #2 is continually energized and the green LED stays on
• Pulse output time - 200ms
• LEDs
  • Red - Power indicator
  • Green - Status indicator (vehicle detected or fault)
• Input / Output protection - Built-in surge and transient protection
• IP Rating - IP54
• Case material - Black ABS plastic
• Operating humidity - Up to 95% without condensation
• Operating temperature - -40°~149° F (-40°~65° C)
• Dimensions - 2 15/16"x1 7/16"x3 5/16" (74x36x85 mm)
• Weight - 7.2-oz (203g)

LD-ACC-WH Specifications PDF