T1MK1F4 Altronix TROVE1M1 12/24VDC @ 4A Fused

Altronix T1MK1F4 kit consists of Trove1 enclosure and TM1 Mercury/Altronix backplane with 12VDC or 24VDC (factory set at 24VDC) @ 4A power supply/charger, 12VDC voltage regulator and four (4) fuse protected output access control module. This kit also accommodate various combinations of Mercury/Lenel* boards for up to four (4) doors in a single enclosure. Trove simplifies board layout and wire management, reduces installation time and labor costs.

Specifications

Power Supply (eFlow4NB)

• Voltage - 120VAC, 60Hz
• Fuse Rating - 5A/250V

Output

• Voltage - 24VDC
• Current - 4A continuous
• Other - Overvoltage protection. Filtered and regulated

Battery Backup

• Capacity - 7AH / 12VDC (Up to 2 within enclosure), 40 AH / 65 AH (requires separate enclosure)
• Type - Sealed lead acid or gel type
• Fuse Rating - 7.5A/32V
• Failover - Upon AC loss, instantaneous

Supervision

• AC Failure - Form "C" contacts
• Battery - Form "C" contacts
• Low DC Power Shutdown - Shuts down DC output terminals if battery voltage drops below 70-75% for 24V units (depending on the power supply). Prevents deep battery discharge

Indicators (LED)

• Input - 120VAC is present
• DC Output - Powered
• Battery - Discharged or not connected

Voltage Regulator (VR6)

• Voltage - 24VDC from eFlow4NB

Output

• Voltage - 12VDC
• Current - 6A continuous
• Other - Surge suppression

Indicators (LED)

• Input - 24VDC is present
• Output - Powered

Access Power Controller (ACM4)

• Voltage - 24VDC from eFlow4NB
• Input Fuse - 10A/32V

Output

• Voltage - 24VDC
• Four (4) independently controlled 2.5A outputs - Four (4) Fail-Safe and/or Fail-Secure power outputs., Four (4) dry form "C" 5A rated relay outputs, Any combination of the above
• Four (4) auxiliary power outputs (unswitched)

Outputs Ratings

• Fuses - 3A/32VDC

Indicators (LED)

• Red LEDs - Outputs are triggered (relays energized)
• Green LED - FACP disconnect is triggered

T1MK1F4 Kit:

• Agency Listings - All components of this Trove kit are UL Listed sub-assemblies. Please refer to the corresponding Sub-Assembly Installation Guides for further information.
• CE - European Conformity

Physical and Environmental

• Dimensions (H x W x D) - 18" x 14.5" x 4.62" (457.2mm x 368.3mm x 118.0mm)
• Product Weight - 16.23 lbs. (7.36 kg)
• Shipping Weight - 20.23 lbs. (9.07 kg)
• Operating Temperature - 0ºC to 49ºC (32ºF to 120ºF).
• Storage Temperature - -20ºC to 70ºC (-4ºF to 158ºF)
• Relative Humidity - 85% +/-5%
• BTU/Hr. (approx.) - 90 BTU/Hr.

T1MK1F4 Specifications PDF