SWX-FMT-CC SimpleWorx Fixture Module Transmitter - White

The Fixture Module Transmitter is a wire-in module that accepts a single low voltage contact closure input to trigger SimpleWorx receivers. The input can be connected to any Class 2 low-voltage devices such as an alarm panel, switches, motion sensors, photo sensors, etc. The FMT-CC can be mounted inside of any fixture or Electrical box.

Specifications

Electrical

• Power Requirements - Primary: 120 Volts AC, 50/60Hz Single Phase
• Neutral Wire - Required
• Channels - One
• Switch Load Types - Incansdescent, Fluorescent, Ballast, Induction, LED, Motor
• Relay Lifetime: - 100,000 on/off operations at full electronic ballast load
• Connections/Power Wire - two 14 AWG gauge 105C insulation, Black – Hot/Line, White – Neutral, Two 22 AWG gauge 105C insulation, Red - Common, Yellow - Trigger
• Standby Power Consumption - < .8 Watts
• Environmental Conditions - Indoor Use Only, Temperature: -40° to 140°F (-40° to 60°C), Humidity: 10% to 90% RH (non-condensing)
• Certifications - Safety tested for USA and Canada ETL tested to UL508, UL-508-2010 CSA C22.2 #14-2010

Operation

• Status LED Modes - Red = Operation Mode, Blinking Green = Link Mode
• Trigger - Contact input
• During Power outage - Retains all settings in Non-volatile EERPOM

Mechanical

• Set Button - Button
• Wire Nuts - 2 included
• Mounting - Single Gang, 1/2" Knock out Stardard J Box, Surface or recessed mount module, mounts in fixture ballast compartment
• Dimensions - Height: 2.8 in Width: 1.60 in Depth: 2.25 in
• Weight - 4.0 oz.
• Warranty - 5 years
• US Patent No. - 6,734,784; 6,784,790; 7,265,654; 7,688,183. U.S. and foreign patents may be pending.

Modes Descriptions

• Normal - Power Is applied to device
• Link - Press and Hold Rocker or Button for >6 sec.
• Link Exit - Tap while in Link Mode
• Test Mode - 5 taps while in NORMAL Mode of a Transmitter
• TEST Mode Exit - 1 tap while in TEST Mode
• Signal Strength Mode - 6 taps while in NORMAL Mode of a Receiver
• Noise Strength Mode - 7 taps while in NORMAL Mode of a Receiver
• Factory Default - 10 taps while in LINK Mode

Led Indicator Status

• Red - Normal Mode Power Applied
• Blinking Green - Link Mode
• Flashes Green - Transmitting
• Dark/Green - Test Mode
• Pulses Green 1-16X - Same Phase/ Signal Strength Display Mode of a Receiver
• Pulses Red 1-16X - Opposite Phase / Signal Strength Display Mode of a Receiver
• Pulses Orange 1-16x - Relative Noise Strength at Receiver
• Blinks Red 10x - Indicates that device has been factory defaulted

SWX-FMT-CC Manual