[DISCONTINUED]ADACSNET American Dynamics USB CCTV Control Module with Install Kit and USB Cable

The ADACSNET SensorNet USB Control Module provides the tools necessary to program, control, monitor and upgrade American Dynamics’ SpeedDomes. A suite of utilities has been developed for this purpose. The first component of this utility package allows the user to program and control a SpeedDome through the USB port on a laptop or PC using a “virtual” TouchTracker.
With this capability, field or bench testing of a dome just got that much easier. Also included is the ability to monitor the SensorNet protocol communication flow and even update a SpeedDome Ultra or Optima dome firmware to the latest release. Now there is no need to climb a ladder or rent a lift to upgrade your American Dynamics’ SpeedDome.

Specifications

USB

• Bit Rate - 1.5 Mb/s Low Speed, 12 Mb/s Full Speed
• Maximum Cable Length
  • 3 m (9.8 ft) for 1.5 Mb/s
  • 5 m (16.4 ft) for 12 Mb/s
• Specification - Universal Serial Bus USB Specification Revision 1.1
• Connector - USB Type B receptacle
• Power Source - 5.0 VDC +/- 5%, 0.75 W from USB host controller port (power adapter not required)

SensorNet

• Address Range - 1 to 254 (configurable)
• Bit Rate - 230.4 Kbps
• Network Distance - 1 km per node
• Maximum Loads - 32 per node
• Node Repeaters - SensorNet junction boxes
• Topologies Supported - Daisy chain, Backbone, or Star
• Transmission Medium - Single non-polarized unshielded twisted pair UTP 22 AWG
• Connector - Euro-style 2 pin removable plug 3.5 mm terminal block
• Terminating Resistor - 120 ohms, switch selectable
• Physical Layer - RS-485, transformer isolated, 2-wire
• Data Encoding - FM-0
• Link Layer Framing - SDLC/HDLC
• Link Layer Channel - Bi-directional, half duplex
• Collision Avoidance - Polling by USB Module
• Application Protocol - Proprietary
• Network Nodes - Domes, junction boxes, secondary TouchTracker, and SensorNet I/O unit

Surge Protection

• SensorNet Gas discharge tube impulse rated at
  • DC breakdown voltage - 90 V
• Insulation resistance - 10,000 Mega ohms
• Capacitance - 2 pF max. 8/20 μs impulse
• discharge current - 10 kA Ten 8/20μs impulses
• discharge current - 5 kA
• Isolation transformer coupled - 2000 Vrms
• PTC re-settable fuse protects transformer
• Transient voltage suppressors (TVS)
• Break down voltage - 7.6–9.3 V
• Peak current - 40 A
• Capacitance - 2000 pf @ 1kHz

Environmental

• Temperature Operating - 10° to 50°C (14° to 122°F)
• Relative Humidity - 0 to 95% non-condensing

Mechanical

• Length - 10.2 cm (4.0 in)
• Width - 7.0 cm (2.8 in)
• Thickness - 2.5 cm (1.0 in)
• Weight - 0.5 kg (1.1 lbs)

Regulatory Compliance

• EMC
  • 47 CFR, Part 15
  • ICES-003
  • EN55022
  • CISPR 22
• Safety
  • UL 1950
  • CSA C22.2 No 950
  • TUV Rhienland EN60950
  • IEC 950

ADACSNET Specifications PDF