[DISCONTINUED] AU7398 Legrand On-Q LyriQ Single Source Main Input

The Single Source Input typically resides at the entertainment center and is connected to the enclosure mounted Audio Distribution Module using a single Category 5 cable run. This Single Source Input requires line level output from the audio source being distributed. If your receiver does not have a dedicated line level or preamp output, use the tape monitor output. The Single Source Input provides RCA jacks for audio source equipment connection. The line level audio signal is sent to the Audio Distribution Module over the Category 5 cable. IR signals that are transmitted to any Category 5 Audio Volume Control within the system are directed to source equipment using IR emitter cables (F7425) that plug into the three 2.5mm jacks on the Single Source Input.

Specifications

General Info

• Cable Type - Cat5, RCA Audio
• Color - Black
• Finish - Powder Coat
• Product Series - Classic
• Type - Audio Source Input
• Input Plug Type - RCA, RJ45, 2.5mm IR

Listing Agencies/Third Party Information

• UN SPS C - 45111801

Construction Information

• Installation Location - Entertainment Center (typical)

Dimensions

• Depth ( Metric) - 3.49 cm
• Depth (U S) - 1.38"
• Height Metric - 6.2 cm
• Height U S - 2.45"
• Width Metric - 13.3 cm
• Width U S - 5.25 in

Technical Information

• Material - Cold Rolled Steel (20GA Front, 16GA Back)
• Power Requirements - Received through lyriQ Distribution Module
• Receptacle Type - 2x Gold-Plated RCA Audio In Jacks, 1x RJ45 Audio Out Jack, 3x 2.5mm IR Emitter, 1x IR Input

AU7398 Specifications PDF

AU7398 Installation Manual