[DISCONTINUED] LM110RP Xantech Smartpad3 Single-Gang Learning Module RP

Single Gang Learning Module receives its program from the PM110 Programmable Module or Universal
Drop-IR. The installer programs the PM110 or Universal
Dragon Drop-IR with the codes and functions intended for the LM110 single-gang module and then transfers (clones) these codes into the LM110 either before or after installation.

Specifications

• Memory - 8 kbytes E2PROM
• IR Carrier Frequency - 31.25 kHz to 71.50 kHz
• Power Requirements - 12V DC (75 mA without STATUS - 85 mA with STATUS)
• Connector - 4-screw terminal block: +12V, STATUS, GND and IR OUT (Requires Xantech 782 Power Supply)
• Conductors - Normal 3-wire Xantech IR receiver system compatible (4th wire for STATUS indication)
• Cable Requirements - Four-conductor/24 gauge up to 150', 22 gauge up to 400', 20 gauge up to 1500' and 18 gauge up to 4000'
• Maximum peak IR signal output current - 100 milliamps
• STATUS Terminal Power Management Turn-on Voltage - 5 to 30 volts DC (8mA @ 12V DC)
• COM Port - RS232 Signal Compatible
• Speaker Relay - Stereo Speaker Pair Muting
• Contact Rating - 2 Amps/30V DC (Will handle amplifiers rated up to 100W/channel)
• IR Commands - ON, OFF, TOGGLE (RC68 Code)
• Factory Default Speaker Relay IR Command - #10 Button on RC68, Toggle
• Factory Default Code Group Setting - D8
• Depth behind mounting plate (including terminals) - 2-1/4" (57 mm)

LM110RP Installation Manual