[DISCONTINUED] PM110RP Xantech Smartpad3 Double-Gang Learning Module RP

Dual Gang Programmable Module (with 32 kbytes E2PROM) is the base module for programming all of the functions required for each installation. All IR codes are learned by the PM110. All sequences (macros) are programmed in this module.

Specifications

• Memory - 32 kbytes E2PROM
• IR Carrier Frequency - 31.25 kHz to 71.50 kHz
• Power Requirements - 12V DC (75 mA without STATUS - 85 mA with STATUS)
• Connector - 4-screw terminal block: +12V, STATUS, GND and IR OUT (Requires Xantech 782 Power Supply)
• Conductors - Normal 3-wire Xantech IR receiver system compatible (4th wire for STATUS indication)
• Cable Requirements - Four-conductor/24 gauge up to 150', 22 gauge up to 400', 20 gauge up to 1500' and 18 gauge up to 4000'
• Maximum peak IR signal output current - 100 milliamps
• STATUS Terminal Power Management Turn-on Voltage - 5 to 30 volts DC (8mA @ 12V DC)
• COM Port - RS232 Signal Compatible
• Speaker Relay - Stereo Speaker Pair Muting
• Contact Rating - 2 Amps/30V DC (Will handle amplifiers rated up to 100W/channel)
• IR Commands - ON, OFF, TOGGLE (RC68 Code)
• Factory Default Speaker Relay IR Command - #10 Button on RC68, Toggle
• Factory Default Code Group Setting - D8
• Depth behind mounting plate (including terminals) - 2-1/4" (57 mm)

PM110RP Specifications PDF

PM110RP Installation Manual